Filter
Top Products
Precision - Page 27
15. Remote Start Program. This dual program branch sets the engine mode for Gas or Diesel, and
learns the vehicle’s RPM threshold. For installation into a diesel equipped vehicle, first set the engine
type to diesel before learning RPM.
RPM Learn.
After engine type is set, start the engine, re-enter Branch 15, LED will start flashing if
tach signal is detected, otherwise the LED will stay solid. Press Button 1 to learn the vehicle’s idle
speed. The horn will honk once to confirm. The horn will honk four times if the tach signal was not
learned.
Gas Engine.
Sets the engine type for Gasoline.
Diesel Engine. Sets the engine type for Diesel and monitors the glow plug input to make sure the
glow plugs are warm before cranking the starter. If the glow plug wire is not connected, the built-
in timer waits 15 seconds before automatically cranking the starter.
16. Ignition 2 Relay Program. Selects one of three operating modes for the Ignition 2 relay output:
Ignition 2, Accessory 2, or Starter 2.
17. Horn Output. When set for Horn Output the horn wire will pulse when the alarm is triggered. When
Ignition 3 Output is selected, the output will activate during remote start to trigger a relay for Ignition
3.
18. Turbo Timer. When enabled, if the emergency brake has been applied Ignition power will be kept
On for a predetermined time (2 minutes. Factory Default) from the application of the emergency brake.
19. Extended Parking Lights. When Enabled, upon Disarming Parking lights will turn On for 30 sec.
20. Horn honk Mode. Normal mode - sets horn honk timing for most vehicles. Extende mode - extends
horn honk for vehicles that require longer horn honk timing.
21. Key-Less Entry honks. When enabled, system honks when lock or unlock are activated using the
remote control. When disabled, no honks will sound upon lock or unlock.
22. Remote Start Confirmation honks. When enabled, system honks before the starter is activated.
When disabled, no honks will sound upon start.