Scytek electronic 2200 Automobile Alarm User Manual


 
Precision - Page 7
CHP Set the siren*/horn confirmation chirps*/honks ON or OFF:
1. Press and hold Button 5 until the display shows CHP.
·The transmitter will beep three times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will show a siren if the chirps*/honks are enabled or "off" if the chirps*/honks are
disabled.
snd sound function selects the transmitter's confirmation mode - Tone or Vibration mode.
Set the transmitter confirmation tones ON or OFF:
1. Press and hold Button 5 until the display shows SND.
· The transmitter will beep four times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD transmitter will beep 5 times and display “on” if the sounds are enabled or vibrate and
display "off" for the Remote to vibrate.
PSV* passive mode function enables or disables the security systems passive arming mode.
Enable or disable the passive arming mode:
1. Press and hold Button 5 until the display shows PSV.
· The transmitter will beep five times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will play a tone and display “on” if enabled or "off" if disabled.
VLT Valet mode function sets and resets the security system valet mode.
** this function is enabled only when the system is disarmed/ unlocked.
Set or reset the Valet mode:
1. Press and hold Button 5 until the display shows VLT.
· The transmitter will beep six times.
2. Release Button 5.
· The LCD panel will play a tone and the siren*/horn will chirp/honk once if the Valet mode was set
and the symbol “V" will be displayed indicating that the system is in Valet mode.
· The transmitter will beep twice and the siren will chirp twice if the Valet mode was reset. The symbol
“V" will turn off indicating that the security system is out of Valet mode.
C
O
Auto Start Cold Temperature Activation Mode.
1. Press and hold Button 5 until the display shows
C
O
.
· The transmitter will beep 7 times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will show Auto Start Cold Temperature setting.
3. Press and hold Button 5 until the display shows CON.
4. Release Button 5.
· The transmitter will beep once.
· The LCD panel will show "ON" indicating that Auto Start Cold Temperature Activation
Mode is enabled.
h
O
Auto Start Hot Temperature Activation Mode.
1. Press and hold Button 5 until the display shows
h
O
.
· The transmitter will beep 8 times.
Repeat steps 2-4 above.