Schumacher IP-1850FL Automobile Battery Charger User Manual


  Open as PDF
of 30
 

Ensure the battery clips are securely clipped on the storage holders.1.
2.
3.

4.
breaker of the Instant Power™ will trip and disconnect the power to the device. If this

on the back of the Instant Power™ to reset the circuit breaker.

DC device may result in excessive battery drain. Recharge immediately after unplugging

Appliance Type Estimated Wattage Estimated Usage Time
Cell Phone 4 watts 54 hours
Fluorescent Light 4 watts 54 hours
Radios, Fan 9 watts 24 hours
Depth Finder 9 watts 24 hours
 15 watts 14.4 hours
Electrical Tool 24 watts 9 hours
Electrical Cooler 48 watts 4.5 hours
 80 watts 2.7 hours
NOTE: Estimated run-times. Actual time may vary. Times are based on the internal
battery being fully charged
Flex Light Light Bulb Replacement10.3
The bulb used in the IP-1850FL light is a 12 volt, 5 watt halogen bayonet type.
Disconnect the Flex Light from the Instant Power™.1.
To replace the bulb, unscrew the cover on the lamp back, remove the old bulb, then 2.
replace with a new 12 volt, 5 watt halogen bulb.
Finally screw the cover onto the lamp housing.3.
Using the Built-In Light10.4
1.
Ensure the battery clips are securely clipped on the storage holders.2.
3.
The Instant Power™ light will turn on and illuminate your work area.4.
5.
Charge the Instant Power™ as soon as possible after using the work light.6.
MAINTENANCE INSTRUCTIONS11.
After use and before performing maintenance, unplug and disconnect the Instant 11.1

Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips, 11.2
cords, and the Instant Power™ case.
Ensure that all of the Instant Power™ components are in place and in good working 11.3
condition, for example, the plastic boots on the battery clips.
Servicing does not require opening the unit, as there are no user-serviceable parts.11.4
11.5
MOVING AND STORAGE INSTRUCTIONS12.
Store the Instant Power™ in an upright position. 12.1
Store inside, in a cool, dry place.12.2
 previous next