Filter
Top Products
To raise the seatback, do the following:
1. Lift the recliner lever, located on the outboard
side of the seat, up fully and push up on the
seatback.
2. Continue raising the seatback until the
seatback re-engages.
{CAUTION:
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on
the seatback to be sure it is locked.
3. Push and pull on the seatback to make sure it
is locked in place.
The recliner lever is also used to recline the
seatback while a passenger is seated. See Manual
Reclining Seatbacks on page 12.
Rear Seats
Split Folding Rear Seat
The rear split bench seatbacks have three
available positions — folded forward, upright, or
partially reclined. Each of the rear seatbacks
can be moved to any of the three positions
independent of the other seatback position.
{CAUTION:
A safety belt that is improperly routed,
not properly attached, or twisted will not
provide the protection needed in a crash.
The person wearing the belt could be
seriously injured. After raising the rear
seatback, always check to be sure that
the safety belts are properly routed and
attached, and are not twisted.
18