Sanyo CH4242 Automobile Accessories User Manual


 
45
S4359146
6.
HOW TO INSTALL THE WIRED REMOTE CONTROLLER
(
OPTIONAL PART
)
Fig. 6-2
66
66
6
RC
(WD)
1987_C_I
3-21/32 in. or more
Spacer
Wall
3/32 in.
(amount offset from JIS box)
Hole for routing
remote control
cable
3-17/32 in. or more
4-29/32 in. or more
4-29/32 in. or more
(from wall)
(during continuous
installation)
(from wall)
(during continuous
installation)
JIS CB8340
One switchbox
(no cover)
1988_C_I
Spacer
Wall
Hole for routing
remote control
cable
3-17/32 in. or more
4-29/32 in. or more
(from wall)
(during continuous
installation)
JIS CB8340
Two switchbox
(no cover)
Fig. 6-1
6-1. Installation site selection
Install the remote controller at a height of between
3–5 ft. above the floor.
Do not install the remote controller in a place where
it will be exposed to direct sunlight or near a
window or other place where it will be exposed to
the outside air.
Be sure to install the remote controller vertically,
such as on a wall.
The mounting position for the remote controller
should be located in an accessible place for control.
Never cover the remote controller or recess it into
the wall.
Mounting dimensions for continuous installation
When mounting the remote controller on a wall,
please see Fig. 6-1 and Fig.6-2.