Filter
Top Products
8-2-4
MAIN SYSTEM
(1)
Remove the bolt (12) and take out float chamber body
(13).
(2)
From the
body
(14)
remove the main nozzle
(15),
and then remove the main jet
(16)
and
(3)
Reassembly
guide holder
(17)
from
the main nozzle
(15).
a) Fasten the main jet securely to the body. Otherwise, the fuel may become too rich and cause
b)
The bolt tightening torque is
70kg
-
cm. Be sure to set the gasket
(19)
and washer
(18)
for
engine malfunction.
chamber
(
13).
8-2-5
FLOAT SYSTEM
(1)
Pull out the float pin (20) and remove the float (21) and then remove the clip (22) and needle
valve
(23).
If the needle valve need to be replaced, replace it with rubber needle.
When cleaning the jets, use neither a
drill
nor a wire (because of possible damage of the
orifice which will adversely affect fuel
flow).
Be
sure
to
use compressed
air
to
blow
them
clean.
(2)
When removing the needle valve
and
float, gently tap the reverse side using the rod more
slender than the float
pin
and remove, since the float
pin
is
calked to the carburetor
body.
-
48
-