Filter
Top Products
(8)
Install control panel to bracket.
(9)
Put choke knob wire through grommet on cleaner base and fasten
to
swivel on choke shaft
Connect wires.
of
carburetor.
(10)
Put element into air cleaner and fasten with wing
bolts.
Install air cleaner cover.
-
End of the reassembly
-
5-
5
BREAK-
IN
OPERATION
An
engine that has been completely overhauled
by
being fitted with
a
new piston, rings, valves
and connecting rod should be throughly
RUN-IN
before being put back into service.
Good bearing surfaces and running clearances between the various parts can only be established
by
operating the engine under reduced speed and loads
for
a
short period
of
time.
While the engine
is
being tested, check
for
oil leaks.
Make final carburetor adjustment and regulate the engine operating speed.
I
Steps
I
Load
6.
MAGNETO
6-
1
.FLYWHEEL
MAGNETO
The ignition system
of
the
EH30./EH34
is
pointless flywheel magneto
with
automatic advancing
characteristic.
Being different from the breaker point type ignition system, this system is completely free from
such troubles as starting-up failure
owing
to dirty, burnt or corroded point surface.
The electronic automatic advancing ensures extremely easy starts and stable high performance
at.
operating speed by advancing the ignition timing to the most suitable point.
-
42
-