Filter
Top Products
1 Cable boss 2
F&g
studs 3
Thmb
nuts 4 Gasket
1.2 Mounting Procedure
Make sure that the selected location is clean, smooth and flat.
1.
2.
3.
4.
Apply the self-adhesive template (supplied) to the selected location
and mark the centres for the
futing
studs (2) and the cable boss (1).
Drill two 4mm (5/32in) clearance holes for the fixing studs (2) through
the bulkhead. Remove the template.
Cut the clearance hole for the cable boss (1) using a 50mm
(2in)
diameter cutter.
5.
6.
Screw the two fixing studs (2) into the control head.
Pass the SeaTalk cable and transducer tails through the cableboss
(1) clearance hole.
7.
Assemble the control head to the bulkhead and secure from behind
0
using the thumb nuts
(31.
L
Bracket Mounting
The ST50 Plus Multi can, as an alternative, be bracket mounted using the
Autohelm
Mounting Kii (Cat. No. D130).
2
Note: Because the instrument breathes through the vent in the rear case,
.
this bracket is for interior use only.
Flush Mounting
A flush mounting
kit
is available for installations where a flush mount is
required or more desirable. Full installation instructions are provided with
the
kit
(Cat. No. D187).