Filter
Top Products
On Power-Up
Action Display Shows
1
Press DEPTH and LOG together for 4 CAL after 2 seconds and
seconds
ZO98VX after 4 sec.
2
Press DEPTH once
CODELOCK
Cal. Off
3 4
seconds after ‘CODELOCK Cal. Off ENTER CODE
4
Press LOG
I
I
-
_--
5
Press HDG or WIND to select first
1
---
number
6
Press LOG to accept number
1
I
I
---
7
Press HDG or WIND to select second
12--
number
8
Press LOG to accept number
1
2’-‘-
9
Press HDG or WIND to select third
123s
number
10 Press
LOG to
accept
third number
1
2
3’-’
11
Press HDG or
WtND
to select fourth 1234
number
12
Press LOG to accept
code
‘1234
13 Press LOG
PWR ON?
14 Press LOG within 10 seconds
CODELOCK
Cal. set
15
To exit CODELOCK, press DEPTH and
Normal operation
LOG together for 2 seconds
ff
you do not exit
‘CODELOCK Cal. set’
within
10
seconds the display will
change to
CANCEL CODE. You
now have the option of cancelling the
code, by pressing LOG to return to the __ __ display, or exit as de
scribed in action 15 above.
Your Code Number
For future reference, enter your chosen code number into the box below.
For obvious reasons, please store this handbook in a safe place.
Operation
When the unit is powered on you are prompted to enter the code number.
To enter the number, carry out actions 4 to 12 above and press LOG.
Chapter 5: Calibration
The ST50 Plus Multi can be adjusted to suit your particular requirements
using the initial, intermediate and extended calibration menus described in
this section.