Filter
Top Products
ST50
plus
Multi Of)eration and lrstalfatjon Handbook
Chapter 6: General SpecScation
Extended Calibration Notes
With the exception of the damping menus, which are adjusted using HDG
and/or WIND, the following options are modified using the WIND key.
Calibration On/Off
Calibration allows you to protect your selected settings. When calibration
is enabled the initial and intermediate calibration cannot be modiiied.
CAL 0 = Calibration locked, i.e. no access
CAL 1 = Calibration unlocked, i.e. normal access
Once locked calibration can be unlocked by entering extended calibration
and selecting 1, calibration unlocked
(the
factory default is
1).
Damping (Speed, VMG and True Wind)
Damping adjusts the averaging applied to the displayed dated. The default
setting is 4, however, the range is between 1 and 15.
Boat Show
Boat Show mode is a dealer demonstration program only. Under no
circumstances must this program be engaged when this unit is installed
on-board your vessel. The display must, therefore, be left set to
‘BSHOW 0’.
Remote Transmission
The ‘MULTI’ option is for future use only and should be set to
1.
Bus (True or Magnetic)
This option is set to true or magnetic, depending on whether the informa-
tion on the SeaTalk bus is true or magnetic (the factory default is
magnetic).
Exit Extended Calibration
Press and hold DEPTH and LOG for 2 seconds to exit extended
calibration.
Chapter 6: General Specification
Dimensions:
Power supply:
Power consumption:
Temperature range:
Illumination:
110xllOmm(4.33x4.33in)
10 to 16V
30ma (normal)
lOOma
(illumination on)
0 to 70 deg.C
3 levels plus off