Filter
Top Products
14
SETTING THE VG-2 OPTION
VG-2 is a system used by some law enforcement agencies
that detects the use of radar detectors in vehicles. It does this
by detecting the weak radio signals used in radar detectors.
Your radar detector can sense a VG-2 system and shift its
operating frequencies out of the range detected by VG-2, mak-
ing your radar detector essentially invisible to this system.
To turn the VG-2 option on or off, press
P
•
V
and
MUTE
at the
same time. Then press
CITY
. The third ALERT indicator turns
on and the detector beeps once to indicate the VG-2 option is
on. If the VG-2 option is off, the ALERT indicator turns off and
the detector beeps once.
After you set this feature, press
P
•
V
again. The detector
beeps.
RECEIVING AND IDENTIFYING
ALERT SIGNALS
Your detector gives different audible alerts for each signal. In
addition, the alert tone pulse rate increases with signal
strength. (See “Demonstrating Alerts” on Page 12 to find out
how the detector alerts you to X-, K-, Ka-band, safety warning
system, laser, and VG-2 signals.)
When your detector senses instant-on radar, it sounds an
intense, 3-second tone and flashes all ALERT indicators.
22-1667.fm Page 14 Friday, August 6, 1999 10:07 AM