Filter
Top Products
© 2008 Directed Electronics—all rights reserved
30
Timer mode
To activate the runtime of the vehicles engine during remote start:
1. Press the button two-times and then .
2. The vehicle will confirm with 4 fast parking light flashes.
3. The system will start every 3 hours until canceled by the brake,
hood, or neutral safety shut-down wires. The remote will respond
with the Start and Stop remote start notification during each Start
and Stop of the Vehicle while in Timer mode.
Important! Timer Mode should be used only in open areas. Never
start and run the vehicle in an enclosed space such as a garage or
carport.
To exit timer mode, Press the button two-times and then again.
Turbo timer mode
Turbo timer mode keeps the engine running after arriving at your
destination for a programmable period of 1, 3, 5 or 10 minutes. This
allows the system’s timer to conveniently cool down the turbo after
you have left the vehicle.
Transmit the timer mode feature with the remote while the engine is
running, press two-times and then . After exiting the vehicle,
arm the alarm and the vehicle will remain running for the programmed
runtime. (The remote start feature is still enabled).
The system monitors the engine speed and will automatically shut the
engine off if the RPMs rise above or fall below the programmed levels.
This feature prevents damage to the motor due to fuel delivery system
failures or other problems which may cause the engine to race.
Note: To enter turbo timer mode with a manual transmission, perform
the manual transmission procedure (See p.29), with the door open.