Filter
Top Products
© 2008 Directed Electronics—all rights reserved
21
Arming the system
To arm the system, press the button on the remote control.
The siren in the vehicle will “chirp” once and the parking lights will
flash once. If the power door locks have been connected, the doors
will lock. The system will automatically check for errors when it arms.
The 2-way remote will “chirp” once and blink the LOCK indicator to
confirm arming. If no arm confirmation is received, the remote will
give the Out-Of-Range signal.
If errors are found when arming:
If an alarm trigger zone – such as a door, the trunk, the hood, or a
sensor, was active at the time of arming, the system will “bypass”, or
ignore, this trigger zone. This allows the system to continue to protect
your vehicle using the remaining trigger zones.
You are notified of this active zone immediately after arming the sys-
tem. The siren in the vehicle will “chirp” again and the parking lights
will flash again. The Status LED indicator in the vehicle will blink in a
pattern to indicate the active zone number error which was found (See
Table of Zones on page 36). The 2-way remote control will sound a
short “error” tone, and blink the LOCK and Function indicators.
Arming without the chirp (Silent Arm)
Press the button at the bottom of the remote once, and then press
the button. The system will arm without the confirmation chirp. The
parking lights will flash once. The 2-way remote will blink the LOCK
indicator to confirm arming. If no arm confirmation is received, the
2-way remote will give the Out Of Range signal.