Filter
Top Products
© 1999 Directed Electronics, Inc. Vista, CA 19
A remote that uses the OEM Style Configuration operates similarly to many factory keyless entry remotes. An OEM
Style Configuration transmitter allows arming and disarming with separate buttons. When programmed for OEM
Style Configuration, the transmitter buttons are assigned to the following functions:
two vehicle operation with single transmitter
You can get two-vehicle operation with the transmitters that come with the system; however, you will not be
able to use all the auxiliary channels of the system (or all the auxiliary channels of the other system), unless
using a 475T 4-button transmitter.
Here's what to do:
1. Using the Learn Routine, program Button I into System One as the arm/disarm button. Do this with all four
remotes.
2. Do the same with System Two, except program Button II of all four remotes as the arm/disarm button.
If using DEI
®
475T four-button remotes, all auxiliary channels are available on both vehicles. Before program-
ming, make a list of all channels on each vehicle, and decide which button(s) should control which channel.
For example, if you wanted the top two buttons to control Vehicle One and the bottom two buttons to control
Vehicle Two, here is how each system would be programmed:
VEHICLE 2
Button III Arm/Disarm/Panic
Button IV Channel 2
Buttons III and IV Channel 3
VEHICLE 1
Button I Arm/Disarm/Panic
Button II Channel 2
Buttons I and II Channel 3
Button I ...........................operates.........................Arm/Panic
Button II ..........................operates.........................Disarm/Channel 2
Buttons I and II ................operate ..........................Channel 3
oem style configuration