Filter
Top Products
© 1999 Directed Electronics, Inc. Vista, CA 17
transmitter/receiver learn routine
™
Transmitters are taught to the system using the Learn Routine. This system will learn up to four transmitters.
Both transmitters come factory programmed using Button I for lock, unlock, and panic; Button II for Channel 2
and Silent Mode; and Buttons I and II together operate Channel 3. This configuration can be changed or new
remotes can be added to the system using the Learn Routine. For added security, this Learn Routine can be locked
using the DEI Bitwriter (P/N 998T). If the unit does not respond to the Learn Routine, plug the Bitwriter into
the data port of this unit and verify that the Transmitter Programming is unlocked.
1. Key. Turn the ignition to the run position. (The YELLOW H1/9 wire must be already be con-
nected.)
2. Valet
®
/Program switch. Press and release the Valet
®
/Program switch the correct number of
times corresponding to the desired channel number. Then press the Valet/Program switch
once more and HOLD it. The LED will blink to indicate the selected channel and the horn
will honk (if connected). Do not release the Valet/Program switch.
NOTE: Channel Nine of the Transmitter Learn Routine will delete all transmitters that are pro-
grammed into the system as well as change the operating settings back to the default settings (see
Operating Settings Learn Routine section of this guide). To use this option, select Channel 9 (LED
will blink nine times) then transmit from any button of a known transmitter.
3. Transmit. While holding the
Valet
®
/Program switch, press the button on the transmitter that
you would like to control the selected receiver channel. One honk will confirm that the code
has been learned.
4. Release. Once the code is learned, the Valet/Program switch can be released.
CHANNEL PRESS AND RELEASE
NUMBER THE VALET/PROGRAM SWITCH TO PROGRAM FUNCTION
1 One time Lock/Arm, Unlock/Disarm, Panic
2 Two times Channel 2 output
3 Three times Channel 3 output
4 Four times Lock/Arm, Panic
5 Five times Unlock/Disarm, Channel 2
6 Six times Panic only
7 Seven times Auto Learn OEM Configuration*
8 Eight times Auto Learn Standard Configuration*
9 Nine times Delete all transmitters
* NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.