Filter
Top Products
18 © 1999 Directed Electronics, Inc. Vista, CA
You can advance from one channel to another by releasing the Valet
®
/Program switch and tapping it to advance
channels and then holding it. For instance: You have programmed Channel 1 and you want to program Channel
2. Release the Valet
®
/Program switch. Press it one time and release it to advance from Channel 1 to Channel 2.
Now, press and hold the Valet/Program switch down and the unit will chirp twice. As before, do not release it.
If you want to program Channel 3 after programming Channel 1, release the Valet/Program switch, press it twice
and then release it to advance to Channel 3. Then press the Valet/Program switch once more and hold it. The
horn will honk three times to confirm it is ready to receive the code from the transmitter to program Channel 3.
The learn routine will be exited if:
■ The ignition is turned off.
■ The Valet/Program switch is pressed too many times.
■ More than 15 seconds elapses between steps.
One long horn honk (if connected) indicates that the Learn Routine has been exited.
transmitter configurations
The transmitters can be programmed with the Standard Configuration or OEM Style Configuration by using the
Auto Learn functions in the Transmitter/Receiver Learn Routine.
When programmed for Standard Configuration, the transmitter buttons are assigned to the following functions:
Button I ...........................operates.........................Arm/Disarm/Panic
Button II ..........................operates.........................Channel Two
Buttons I and II ................operate ..........................Channel Three
standard configuration
to exit learn routine
to advance from one channel to another