Filter
Top Products
8580/8590 Vehicle-Mount Computer User Manual 41
Chapter 4: 8580/8590 Installation
The Cable Cover, Grounding Bar & Cables–Assembling
2. Prepare the sealing rings:
• First, check how many cables are to be connected to the 8580/8590.
• Choose the sealing rings according to the cable diameter (3-6.5mm or
5.5-9mm).
• Then, prepare the corresponding number of sealing rings. Do this by
making an incision with a knife at the mark (only to the midpoint of the
sealing rings).
• Make certain that the remaining sealing rings are not cut open!
• Put the correct sealing rings around the cables
3. Fit cables to the 8580/8590:
• Connect all required cables (maximum 6) to the computer interface.
• Next, place the 8580/8590 onto a soft base
Important: The surface of the touchscreen should always be kept free of dirt,
dust, finger marks and so on to ensure full visibility of the display.
Make sure the screen does not get scratched or otherwise
damaged before placing the device face down.
4. Prepare cables and cable cover:
• Locate the cable cover in the position for mounting, at somewhat apart
from the computer.
• Loosely place the cables in loops in the cable sockets of the cable cover,
not in a straight-through position, but transposed, (see diagram). At this
point, push the sealing rings into the cable sockets.