Filter
Top Products
Maxima
29
www.pridemobility.com
VII. DISASSEMBLY AND ASSEMBLY
WARNING! Do not lift beyond your physical capability. Ask for assistance when
necessary while disassembling or assembling your scooter.
To disassemble the scooter:
1. Place the manual freewheel lever in the drive (down) position.
2. Lift the seat straight up and off the scooter. See figure 16.
3. Gently lift the rear shroud off of the scooter. See figure 17.
4. Disconnect the battery tie-down strap that holds the batteries in place.
5. Unplug both black and white 2-pin battery harnesses. See figure 18.
6. Unplug the front-to-rear harness from its mating plug. See figure 19.
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior to
frame separation could result in permanent damage to the scooter.
SEAT
REAR SHROUD
REAR SECTION
BATTERIES
BASKET
FRONT SECTION
Figure 15. The Scooter Disassembled
DISASSEMBLY
You can disassemble the scooter into seven pieces:
the seat, the front section, the rear section, the rear
shroud, the basket, and the batteries. See figure 15.
No tools are required to disassemble or assemble
your scooter, but keep in mind that the disassembled
sections of the scooter take up more floor space than
the assembled unit. Always disassemble or assemble
your scooter on a level, dry surface with sufficient
room for you to work and move around your scooter-
about 5 feet (2 meters) in all directions. Remember
that some scooter components are heavy and you may
need assistance when lifting them.
Figure 19. Disconnecting The Front-To-Rear-
Harness
Figure 18. Disconnecting The Battery Har-
nesses
Figure 16. Seat Removal Figure 17. Rear Shroud Removal