Filter
Top Products
18
Maxima
www.pridemobility.com
Anti-tip Wheels
The front (not shown) and rear anti-tip wheels are an integral and important safety feature of your scooter.
They are bolted to the frame at the front and rear of the scooter.
PROHIBITED! Do not remove the anti-tip wheels or modify your scooter in any way that
is not authorized by Pride.
Motor/Transaxle Assembly (Not Shown)
The motor/transaxle assembly is the electromechanical unit that converts the electrical energy of your
scooter’s batteries into the controlled mechanical energy that drives the scooter’s wheels.
Electronics Module
The electronics module houses all of the scooter’s harness mating plugs and electronic components for
charging the batteries.
Batteries (Not Shown)
The batteries store the electrical energy that powers your scooter. See IV. “Batteries and Charging.”
Main Circuit Breaker (Reset Button)
When the voltage in your scooter’s batteries becomes low or your scooter is heavily strained because of
excessive loads or steep inclines, the main circuit breaker may trip to protect your scooter’s motor and
electronics from damage.
The main circuit breaker reset button pops out when the breaker trips.
When the breaker trips, the entire electrical system of your scooter shuts down.
Allow a minute or two for your scooter’s electronics to “rest.”
Push in the reset button to reset the breaker.
If the breaker trips frequently, you may need to charge your batteries more often. You may also need
to have your authorized Pride Provider perform a load test on your scooter’s batteries.
If the main circuit breaker trips repeatedly, see your authorized Pride Provider for service.
Fuses
The fuses help protect your scooter’s lighting, control console assembly, and charging systems from
receiving an overload of electrical current. The fuses used in the scooter are the same type automobiles
use.
If a fuse must be replaced, use only the specified amp fuse. See IX. “Care and Maintenance.”
III. YOUR SCOOTER
Docking Device Assembly
Your scooter is equipped with a docking device assem-
bly. See figure 7. In order to utilize the docking device, it
is necessary to purchase an insert (T-bar or Bullnose and
C-arm) that, when used with the lift system, will aid in
lifting your scooter.
Contact your authorized Pride Provider for more informa-
tion about the docking device.
Figure 7. Docking Device Assembly
DOCKING
DEVICE