Filter
Top Products
6-35
4. Disconnect the bulb base
from the socket by
lifting the plastic
locking tab.
5. Snap a new bulb into the socket.
6. Reinstall the bulb assembly by reversing
Steps 1 through 3, making sure the lower leg of
the headlamp bracket is properly seated into the
wedge
-shaped retainer.
Center High-Mounted Stoplamp
(CHMSL)(Models Without a Spoiler)
To change the bulb, do the following:
1. Open the trunk and view the access hole under
the rear shelf.
2. Remove the bulb socket by twisting it in either
direction, then pull down.
3. Remove the bulb and replace.
4. Reinstall the new bulb and socket into the CHMSL.
Center High-Mounted Stoplamp
(Models With a Spoiler)
To change the bulb, do the following:
1. Use a TORX screwdriver to unscrew the bulb
assembly from the spoiler.
2. Gently pull out the bulb assembly.
3. Remove the bulb(s) by gently wiggling the bulb
from the assembly.
4. Replace the bulb(s) and reverse these steps to
reinstall the bulb assembly.