Filter
Top Products
3-11
Adjusting the Speakers
BALANCE: Press and release AUDIO until BAL
appears on the display. Then press and hold the up
arrow to move the sound to the right speakers or the
down arrow to move the sound to the left speakers.
“R” and a number will appear on the display when the
sound is balanced toward the right speakers. “L” and
a number will appear on the display when the sound is
balanced toward the left speakers. L and a zero will
appear on the display when the the sound is balanced
between the speakers. Release the up or down arrow
when you find the speaker balance you want or when
the maximum or minimum level is reached.
FADE: Press and release AUDIO until FAD appears
on the display. Then press and hold the up arrow to
move the sound to the front speakers or the down
arrow to move the sound to the rear speakers. “F” and
a number will appear on the display when the sound is
balanced toward the front speakers. “R” and a number
will appear on the display when the sound is balanced
toward the rear speakers. F and a zero will appear on
the display when the the sound is balanced between the
speakers. Release the up or down arrow when you find
the speaker balance you want or when the maximum or
minimum level is reached.
To set BALANCE or FADE to the middle position,
select the desired speaker control. Then press and hold
AUDIO for more than two seconds until you hear a
beep. L and a zero or F and a zero will appear on the
display. To set all of the tone controls and speaker
controls to the middle position, end out of audio mode.
Then press and hold AUDIO for more than two seconds
until you hear a beep. CEN will appear on the display.
Radio Calibration
Your audio system has been calibrated for your vehicle
from the factory. If CAL appears on the display it
means that your radio has not been configured properly
for your vehicle and must be returned to the dealership
for service.