Filter
Top Products
54
PRE-RIDE INSPECTIONS
Before Starting the Engine
n
Hydraulic Brakes
Properly functioning brakes
are critical to your safety.
Always check the following
items to assure proper
operation before starting the
engine.
Brake Lever Travel
When the brake lever is
squeezed, it should move no
closer to the handgrip than
1/2″ (1.3 cm) (A). A
distance less than this indicates low brake fluid level or air in the
hydraulic system. R efer to the brake bleeding information on page 105.
Lever Feel
A hydraulic system multiplies the force of your hand squeezing the
brake lever. Proper operation depends on an adequate supply of air and
moisture-free hydraulic bra ke fluid in the system. If the brake lever
feels “spongy” when squeezed, c heck the level and condition of the
fluid. Also check for the presence of air in t he fluid system. Refer to
page 105 for more information, or see your dealer for service.
Replace brake fluid at least every two years with Polaris DOT 3 high
temperature brake fluid. All DOT 3 brake fluid i s not alike. Use only
Polaris brake fluid. See page 132 for the part numbers of P olaris
products.
WARNING
Continued use of “spongy” brakes may cause a complete loss of
brakes, which could result in serious injury or death. Always have
the brakes serviced at the first sign of sponginess.
A