Filter
Top Products
68
THE PERFECT FIT
Handlebar Component Fastener Torques
Component Torque
Do not over-tighten
IMPORTANT: Moving a handlebar component without first loosening its
screws/set screws may cut grooves into the handlebar, making it difficult
to secure the component. Do not move a handlebar component without
first loosening its mounting screws/set screws.
Take care to avoid damaging hand warmer/brake switch wires when
moving components.
1. Left Hand Control/Brake Master Cylinder 24 in-lbs (2.7 Nm)
2. Upper / Lower Handlebar/Riser Clamps 16 ft-lbs (21.6 Nm)
3. Throttle Lever Block Set Screw 27 in-lbs (3 Nm)
4. Throttle Lever Block Cover Screws 6 in-lbs (0.7 Nm)
5. Auxiliary Engine Stop Switch Set Screw 12 in-lbs (1.4 Nm)
6. Riser Install with the “FWD”
stamp facing forward,
toward the hood.
Hand Guard Mounts (if applicable) Hand-Tight
1
2
3/4
5
6
2
Shown with riser cover removed for clarity