Filter
Top Products
56
OPERATION
Starting the Engine
Starting a Cold Engine (Manual Start)
Do not depress the throttle until the engine starts.
1. Turn key to ON.
2. Pull kill switch (shut-off switch) up to RUN.
3. Flip choke toggle to FULL ON.
4. Grasp starter handle and pull slowly until recoil engages; then pull
abruptly to start the engine.
5. After the engine starts, flip the choke toggle to the OFF position.
If the engine slows or wants to stop, use intermittent choking to the
HALF ON position.
Inadequate cooling and lubrication will lead to overheating of the
slide rail and track, re sulting in premature wear and failure.
Reduce speeds and frequently drive into fresh snow to allow
adequate cooling and polishing of the slide rail and track
surfaces. Avoid operating on ice, har d-packed surfaces or roads.
CAUTION
Before starting the engine, always refer to all safety warnings
pertaining to snowmobile operation. Never start your s nowmobile
without checking all components to be sure of proper operation.
See Check Before Starting the Engine beginning on page 51.
WARNING
Don’t pull the starter rope to full extended position or allow it to snap
back into the housing. Damage may result.
To avoid personal injury and/or engine damage, do not oper ate
the electric starter or pull-rope starter while the engine is running.
CAUTION