Filter
Top Products
Northstar Explorer 538i/538 Installation and Operation Manual
49
• C-MAP™ NT-MAX, NT+ or NT chart cards.
• C-MAP™ user cards (3 V) for storing data. (The older 5 volt cards are not supported)
• Northstar carry bag.
• Northstar NavBus junction boxes simplify wiring, particularly if several instruments are connected.
For more information, see the NavBus Installation Manual.
Note: To select the start point, go to the chart display before starting the simulation. Then:
• To start the simulation from the boat position, press
to switch to centre on boat mode.
• To start the simulation from a different point, move the cursor to that point on the chart.
Tip: To calculate a course, use the cursor (see section 3-3).
Tip: As the boat moves, vary Course to simulate the boat moving off course.
2 Demo
Simulates a boat moving along a route and automatically displays different Explorer 538/538i functions.
The options required for Demo are:
Speed: The simulated boat speed to use.
Route: The route to follow.
• Explorer 538 or 538i display unit
•
Dust cover for display unit
•
Blanking caps for unused connectors
• Power cable
• Mounting bracket (screws included)
• Flush mounting kit
• Northstar 133 GPS antenna for Explorer 538 only;
the Explorer 538i has a built in GPS antenna.
• Warranty registration card
• This manual
Correct installation is critical to the performance of the unit. It is vital to read the entire installation
section of this manual and the documentation that comes with the antenna and any other units before
starting installation.
15 Installation
15-1 Installation: What comes with the Explorer 538/538i
15-2 Installation: Options and Accessories