Filter
Top Products
A. Tighten this nut/bolt down LAST. Torque to 30-35ft lbs
B. Tighten these bolts into the block by hand, and just snug
them for now. We will torque them later. Don’t worry about the
C-shims right now, either.
C. This bolt hole is no longer used
Once you have completed the rear mount/brackets, it’s time to move
on to the front brackets. The front bracket/adaptor will be loosely
assembled. It should be as follows:
A. Torque to 35-40 ft lbs (mounts to front of engine block)
B. Torque to 50ft lbs (will be torqued later)
C. Torque to 50ft lbs (goes through QR front engine mount, will
be torqued later)