Filter
Top Products
**BEFORE YOUR BEGIN**
This kit was design with simplicity in mind. Installing the VQ drive-
train will be fairly straight-forward. However, it will require moderate
automotive knowledge, and the right tools to complete the job. If your
are unsure about the installation, PLEASE, bring your vehicle to a
qualified automotive shop to complete your installation. The hardest
aspect of this installation, is the wiring of the ECU (Engine Control
Unit) harness and sub-harness. Diagrams can be supplied upon
request, which will help you to complete this task. However, the
wiring aspect of this swap is fairly complicated, and should be left to a
very experienced automotive technician. Again, if you are unsure,
PLEASE, ask for help, or have someone who is qualified, do the work
for you. Forced Induction Racing and it’s associates will NOT be held
liable for any damages or injury from the use or misuse of this
product. You are responsible for making your vehicle emission-
compliant. This kit is sold as a off-road kit. It is up to you to bring
your vehicle up to compliance with state/federal laws. Now, on to the
fun part. ☺
At this time, please take the time to go through your parts, and verify
that you have all of the following pieces:
(1) Rear VQ35DE steel mount bracket
(1) Front VQ35DE steel mount bracket
(1) Front QR to VQ stainless mount adaptor
(1) Aluminum VQ35DE passenger side mount bracket
(1) Passenger side QR to VQ stainless mount adaptor
(1) VQ35DE cast iron axle bracket (bearing carrier)
(1) Stainless VQ35DE axle bracket adaptor
(3) “C-shaped” washers (for axle spacing)
(1) Plastic bag of washers (for shimming passenger mount)
(10) M10 x 1.50 bolts (30mm long) and washers
(1) M10 x 1.50 bolt (45mm long) and washer
(1) 3/8” bolt (1.5” long) 2 washers/1 lock nut
(1) 3/8” bolt (2.5” long) 2 washers/1 lock nut
(1) 3/8” bolt (3” long) 1 washer/1 lock nut