Filter
Top Products
This one is pretty easy… There’s a second set of holes that are
closer towards the block. You will use those, instead of the original
holes. Torque the 1/2” bolt/nut to 55ft lbs.
The last step in the mechanical aspect of this install, is to install the
axles. The driver’s side axle, will bolt right in. No modification
required.
For the passenger side axle… You will need to remove the QR
bracket that bolts the axle to the QR block. It is held on by (3) 12mm
bolts. Once you take the bolts off, you will be able to slide the
adaptor off of the axle. Slide the axle through the new VQ axle
bracket (attached to the block already), and into the transmission.
You will slide the (3) 12mm bolts through the VQ bracket next and
thread them back into the QR axle. DO NOT forget to use the
provided “C-shims” between the axle and the bracket. This will space
the axle away from the bracket just a hair, and give you the right