Filter
Top Products
31
iCN 600 series | User Manual
Getting started
Setting Your Destination by POI -
Case Study Two: Australia, Canada & USA
This case study will show you how to set your destination by selecting a Point of Interest (POI).
A POI is a named site, feature, landmark or public venue which can be displayed as an icon on the
map. POIs are grouped by type, such as parks and museums.
Note: This case study applies to Australia, Canada and USA only. For navigating in Europe and
New Zealand, see page 28.
Step One: Open the Destination screen
a. From the Main Menu, select Go To, then press OK.
b. From the Go To screen, select Address or POI, then press OK.
The Destination screen will display.
Important Note:
i. If this is the first time you are setting your destination and you have maps from more than
one country installed and selected, then the Select Country
screen will display instead of
the Destination screen. Go directly to Step Two: Select the Country of Destination,
step b.
The next time you perform this procedure, the Destination screen will open as expected.
ii. If this is the first time you are setting your destination and you have maps from only one
country, but more than one state installed and selected, then the Select State
screen will
display instead of the Destination screen. Go directly to Step Three: Select the State
of Destination
.
The next time you perform this procedure, the Destination screen will open as expected.
Step Two: Select the Country of Destination
If you only have the map of one country installed and selected, that country is selected for
your destination by default and cannot be changed. Go to Step Three: Select the State of
Destination.
a. From the Destination screen, select Change country or Change country or state then
press OK.
The Select country screen will display.
b. Select a country using the 8-way toggle. Press OK to select from the list.
The Select state screen will display.
• If you only have the map of one state installed and selected, that state is selected for
your destination by default. Go to Step Four: Select the Type of POI
.