Filter
Top Products
TRACKER 5380 Installation and Operation Manual
46
NAVMAN
14-6 Setup > Logs
Press one or more times until the
Setup menu is displayed, then select Logs:
The values can be changed independently of
each other. These log values are saved when
the unit is turned off.
Reset trip dist
This resets the trip distance to zero.
Reset total dist
This option resets the total distance to zero.
Reset engine hours
Use this option to reset the engine hours
to zero. This can be useful after an engine
service or to count the engine hours between
service intervals.
14-7 Setup > Alarms
Press one or more times until the
Setup menu is displayed, then select
Alarms:
All alarms except Loss of GPS fix can be
turned on (enabled) or off (disabled).
Symbol Alarm Alarm sounds when it is on and the:
Arrival boat is closer to the destination or to a waypoint
radius than the alarm trigger value
Anchor alarm boat moves by more than the alarm trigger value
XTE boat moves off course by more than the CDI scale
(see section 14-2)
Danger boat comes closer to a danger waypoint than
the alarm trigger value
Low fuel fuel remaining equals the alarm trigger value
Loss of TRACKER can not receive the DGPS signal
DGPS fix (beacon, WAAS or EGNOS)
Loss of TRACKER can not receive the GPS signal
GPS fix (this alarm is always on)
For the
XTE and Loss of DGPS fix
alarms, select to turn the alarm on or select
to turn the alarm off. For the other alarms,
enter a trigger value to turn the alarm on. The
alarm will sound each time the alarm value
equals the trigger value. For example, the
Danger alarm will sound if the boat comes
closer to a danger waypoint than the trigger
value and the
Anchor alarm will sound if the
boat moves by more than the trigger value. To
turn these alarms off, enter a trigger value of
0 (zero).
Icons for alarms that are on can be displayed in
the data header (see section 2-8-2). An alarm
icon is normally black and turns red when the
alarm sounds.