Filter
Top Products
TRACKER 5380 Installation and Operation Manual
10
NAVMAN
c) To change a name or number:
1 Press
to display the name or number:
2 Press
or to select a letter or digit to
change. Press or to change the letter
or digit.
Repeat this to change other letters or
numbers.
3 Press
to accept the new value. Or
press
to ignore the changes.
d) To change a slider value
Press
to decrease the value or to increase
the value.
Operate the TRACKER by selecting items from
menus. Items can be submenus, commands
or data.
Selecting a submenu
A
after a menu item indicates a submenu, for
example Chart . Press or to move
the highlight to the submenu, then press
.
Starting a command
Press
or to move the highlight to the
command, for example Goto cursor, then press
.
Changing data
First press
or to move the highlight to the
data to change, then:
a) To change a tick box
means On or Yes
means Off or No.
Press
or to change the tick box.
b) To select an option
1 Press
to display the menu of options.
2 Press
or to move the highlight to the
option you want, then press
.
2-3 Turning on and off / auto power
Turning on manually
If the TRACKER is not wired for auto power,
press
to turn the unit on. If necessary, adjust
the display to be easy to read (see section 2-4).
Note: If the TRACKER is not wired for auto
power then the TRACKER does not record
engine hours and might not record fuel
consumption (see section 15-4).
Turning off manually
If the TRACKER is not wired for auto power or
if the ignition switch is off, hold down
until
the display turns off.
Auto power
If the TRACKER is wired for auto power (see
section 15-4), then:
The TRACKER automatically turns on when
you turn the boat’s ignition switch on.
You can not turn the TRACKER off while the
ignition switch is on.
If
Auto power off (see section 14-1)
is , the TRACKER automatically turns off
when you turn the boat’s ignition switch
off.
If
Auto power off (see section 14-1)
is , the TRACKER stays on when you turn
the boat’s ignition switch off. You can now
turn the TRACKER off manually.
2-2 Using the menus