Filter
Top Products
User’s Manual NAVIGON 2100 | 2110 max
Troubleshooting - 53 -
9.2 Identification and serial number
The navigation system has various identification labels under the rear
cover. (e.g. CE label, serial number, ...)
If you need to see any of these labels, proceed as follows:
1. Switch off the navigation device.
2. Take the memory card out of the device.
3. With your thumbnail in the slot on the bottom of the device, pull the
rear cover off the device.
To close the rear cover again:
1. Place the cover correctly back in position.
2. Push the cover firmly against the device until it latches home in all
corners.
3. Re-insert the memory card.
Note: We recommend that you remove the rear cover only when told to
do so by our service staff.
9.3 Declaration of conformity
The NAVIGON 2100 | 2110 max described in this manual bears the CE
label among others.
Products with the CE marking comply with Radio & Telecommunication
Terminal Equipment Directive (R&TTE) (1999/5/ECC), the
Electromagnetic Compatibility Directive (89/336/ECC) and the Low
Voltage Directive (73/23/ECC) – as amended by Directive 93/68/ECC –
issued by the European Community Commission.
Compliance with these directives implies conformity with the following
European Standards:
EN301489-1, EN301489-3, EN50332-2, EN55022, EN55024,
EN61000-3-2, EN61000-3-3, EN60950 / IEC 60950,
EN301357-2 V1.3.1
The manufacturer is not liable for modifications made by the user which
may alter the device's conformity with the CE label, nor for the
consequences thereof.
10 Troubleshooting
In this chapter you will find solutions to problems which may arise
during use of the NAVIGON 2100 | 2110 max.