Filter
Top Products
HTXD6i RIDE-ON TROWEL • OPERATION MANUAL —REV. #0 (03/23/12) — PAGE 23
SETUP
The purpose of this section is to assist the user in setting
up a new trowel. If your trowel is already assembled, (seat,
handles, knobs and battery), this section can be skipped.
BATTERY SETUP
1. This trowel was shipped with a wet charged battery.
This battery may need to be charged for a brief period
of time as per manufacturer's instructions.
NOTICE
The new trowel cannot be put into service until the
setup instructions are completed. These instructions
only need to be performed at the time of unpacking a
new trowel.
CAUTION
Use all safety precautions specified by the battery
manufacturer when working with the battery. See Safety
Information section of this manual for more details on
battery safety.
2. To install the battery on the trowel, make sure that the
battery is well seated in the battery box (Figure 10).
Figure 10. Battery Box
3. Connect the positive cable to the positive terminal on
the battery first, then connect the negative cable to the
negative terminal.
4. Close the plastic battery box cover and secure the
battery box.