PAGE 16 — HTXD6i RIDE-ON TROWEL• OPERATION MANUAL — REV. #0 (03/23/12)
DIMENSIONS
Table 3. Trowel Dimensions
A – Length – in. (cm) 96.75 (246)
B – Width – in. (cm) 50.0 (127)
C – Height – in. (cm)
1
57.0 (145)
NOTES:
1. This value includes the seat height (Table 3).
2. Sound pressure is a weighted measure. Measured at the operators ear position while the ride-on trowel is operating
at full throttle on concrete in a manner most often experienced in “normal” circumstances. Sound pressure may vary
depending upon the condition of the concrete. Hearing protection is always recommended (Table 1).
3. The vibration level indicated is the maximum RMS (Root Mean Square) value obtained at the handle grip while operating
the ride-on trowel on curing concrete in a manner most often experienced in “normal” circumstances. Values were
obtained from all three axes of motion. The values shown represent the maximum RMS value from these measurements
(Table 1).
4. “AW” stands for anti-wear and “MV” stands for multi-viscosity. The 68 refers to the general viscosity range and is similar
to 10W-30-motor oil. It is recommended that AW MV 68 hydraulic oil be used. If this type of hydraulic oil is not available
then use 10W-30 engine oil for cold weather or 10W-40 engine oil for hot weather (Table 1).
C
A
B
Figure 3. HTXD6i Dimensions