Filter
Top Products
9
Setting the Map Options
How your map is displayed can be customized
in Settings to your preferences.
1. From the Map screen, tap the MENU
button.
2. Tap the Settings Icon.
3. Tap Map button.
4. Use the Map Options screen to customize
what and how your map is to be
displayed.
Setting the Map Modes (2D or 3D)
The map is normally displayed in 3D mode
(perspective view) but you can set the map to
2D mode (top down view) if so desired.
1. From the Map screen, tap anywhere on
the map. Additional controls appear.
2. Tap 2D to switch the map to 2D mode
from 3D mode, or tap 3D to switch the
map to 3D mode from 2D mode.
3. Tap
.
Setting Zoom Levels
Select the zoom level that best suits your
needs. Note that zoom levels are limited in 3D
mode. As you zoom out in 3D, the display will
switch to 2D at higher zoom levels.
1. Tap the ‘+’ or ‘-’ zoom level buttons at
the bottom of the Map screen to set the
desired zoom level.
Panning on the Map
1. While viewing the Map screen, slide your
finger or a stylus across the map.
2. The map screen changes to Pan mode.
3. When finished, tap and the map
returns to your current position.
Routing to a Panned Position
1. Pan the map until the location you wish
to route to is displayed.
2. Tap on the map at the point you want to
go to. A red push pin will be displayed
along with information about the point
chosen at the top of the screen.
3. Tap the GO button in the top left corner.
4. If an active route already exists, you will
need to define what to do with this new
route point:
Replace Destination:
the next destination
is cleared and replaced with the one
selected from the Pan screen.
Go There Now:
the selected location is
inserted in the route as an intermediate
destination before the next destination.