Filter
Top Products
3
Fundamentals 2
Powering on the Magellan RoadMate
receiver
The Power On/Off switch is located on the top
of the Magellan RoadMate receiver.
Turning the Magellan RoadMate receiver
On
1. Press the power switch.
2. After the initial splash screen the
Warnings screen is displayed. Read and
tap
.
Turning the Magellan RoadMate receiver
Off
1. Press the power switch. The receiver will
automatically power off in 15 seconds.
[Cancel] cancels the power off sequence
and returns to last viewed screen.
[Power Down Now] turns the receiver
off immediately, bypassing the 15 second
delay.
Note: Anytime the power cable is
disconnected from the receiver or if power is
turned off at the 12v power receptacle, the
receiver will begin the power off sequence.
Bluetooth®
Pairing Bluetooth
The instructions shown here are for pairing a
phone for normal use.
1. The first time you use Bluetooth in your
Magellan RoadMate receiver, the receiver
will automatically ask you if you want to
pair a phone.
2. After selecting Yes the receiver is in
pairing mode. Follow the instructions
in your phone manual to set it in pairing
mode.
3. After the phone has searched for new
devices, select “Magellan Roadmate” from
the list.
4. Your phone will ask for a passcode.
5. Enter ‘1234’.Tap Yes on the Magellan
RoadMate.
6. A screen will confirm the successful
pairing.
Battery Levels
The Magellan RoadMate receiver has an
internal battery that is charging whenever
the receiver is connected to external power.
Note: The battery can only be serviced by
authorized Magellan repair facilities.
Viewing the Battery Level Indicator
1. While viewing the Map screen, tap on the
Menu button in the right corner.
2. The battery level indicator is located in
the upper right corner of the Main Menu,
just below the satellite signal indicator.
Green bars indicate battery level.
Speaker Volume
Changing the Volume from the Map
Screen
1. Tap the speaker icon . Additional controls
appear.
2. Tap the speaker button to mute the
volume, or tap the ‘+’ or ‘-’ buttons to raise
or lower the volume.
3. Tap
.