Filter
Top Products
BASIC OPERATION AND FEATURES
2
IMPORTANT: Performing a master reset will reset the unit to the
factory defaults, thus eliminating any installation and calibrations
performed during set up of product.
Press the "-" and "+" buttons simultaneously for approximately 10
seconds (until the graphic bars collide) to restore the unit to factory
default settings. Press the "MODE/SELECT" button to confirm.
22660
MASTERRESET
MASTERRESET
ERASE CALIBRATION !
PRESS MODE/SELECT TO CONFIRM
Auto Detection Engine Function
The System Tachometer/Speedometer and Smart Tow
Tachometer come standard with an Engine Auto-detection feature.
This feature lets the gauge, on the initial power up, automatically
detect which engine type is used and configure the gauge to match
that engine type.
On first time power up of the gauge or after a Master Reset, the
gauge will display "AUTODETECT". Upon pressing the "MODE/
SELECT" button, the gauge will automatically determine engine
type. This will preset the data monitoring screens accordingly. The
intention is to make initial setup easier. Press the "MODE/
SELECT" button to start the Auto Detection Engine function.
AUTODETECT
ENGINE SMARTSCREEN
PRESS MODE/SELECT TO START
24298
If the gauge shows a warning of "NO STARBOARD ENGINE" or
"MULTIPLE STARBOARD ENGINES", the engine location must
be properly selected (Port and Starboard) at the engine using a
Mercury Computer Diagnostic System tool (CDS). Perform the
Master Reset and Auto Detect functions again. (Refer to Master
Reset).