Mercedes-Benz SL 600 Automobile User Manual


 
348
Practical hints
Flat tire
̈ After attaining a tire pressure of 26 psi
(1.8 bar), press 0 on electric air pump
switch 8.
The electric air pump should now be
switched off.
̈ Turn the SmartKey in the ignition to
position 0 (
page 31).
or
̈ Press the KEYLESS-GO* start/stop
button (
page 33) on the gear selec-
tor lever twice. Do not depress brake
pedal.
̈ Detach the electric air pump.
The air hose may still be hot. Please ex-
ercise appropriate caution.
̈ Store the electrical plug and the air
hose behind the flap and place the air
pump back in the trunk.
̈ Close the trunk lid.
̈ Drive away immediately.
The TIREFIT sealant will distribute itself
evenly inside the tire.
Warning! G
If a tire pressure of 26 psi (1.8 bar) is not at-
tained, tire is too severely damaged for
TIREFIT to provide a reliable tire repair.
In this case, TIREFIT cannot properly seal
the tire.
Do not drive the vehicle.
Contact the nearest Mercedes-Benz Center
or call Roadside Assistance.
Warning! G
Do not exceed vehicle speed of
50 mph (80 km/h). A TIREFIT repair is not
designed to operate at higher speeds.
The sticker must be attached on the instru-
ment cluster where it will be easily seen by
the driver.
Vehicle handling characteristics may
change. Adapt your driving accordingly.
୴୴