Filter
Top Products
Resetting
Reset the tilt/sliding sunroof if it does not
open smoothly, or if the battery has been
disconnected or has become discharged.
!
Contact a qualified specialist workshop if
the tilt/sliding sunroof cannot be closed
fully or reset.
X
Remove the SmartKey from the ignition
lock or turn to position 0 (KEYLESS-GO).
X
Remove the fuse for the tilt/sliding sunroof
from the main fuse box. To find out where
the fuse is located, refer to the fuse
allocation chart in the vehicle tool kit
(Y page 294).
X
Reinsert the fuse.
X
Switch on the ignition.
X
Raise the tilt/sliding sunroof fully at the
rear (Y page 92).
X
Keep the 2 switch pressed for another
second.
X
Make sure that the tilt/sliding sunroof can
be opened or closed fully again using the
opening/closing process (Y page 92).
X
If the tilt/sliding sunroof can be raised fully
at the rear it is set correctly. If this is not
the case, you must repeat the previously
described steps.
Operating the panorama sliding
sunroof
Opening and closing
Overhead control panel
:
To raise
;
To open
=
To close
The panorama roof with power tilt/sliding
panel can only be moved when the roller
sunblinds are open.
X
Turn the key to position 2 in the ignition
lock.
X
Push or pull the 2 switch in the
corresponding direction.
i
When opening the panorama roof with
power tilt/sliding panel, you can initiate the
automatic opening process. To do so, press
the 2 switch briefly beyond the point of
resistance in the direction of arrow ;. By
pressing again, the automatic opening
process can be stopped.
Automatic raising is only available if the
panorama sliding sunroof is in the closed
position.
Operating the roller sunblinds of the
panorama sliding sunroof
General notes
The roller sunblinds provide protection from
the sun. The two roller sunblinds can only be
opened and closed together when the
Sliding sunroof
93
Opening and closing
BA 251 USA, CA Edition A 2011; 1; 3, en-US
d2sboike Version: 3.0.3.5
2010-04-16T14:31:55+02:00 - Seite 93
Z