Filter
Top Products
365
Operation
Tires and wheels
̈ Switch on the ignition (୴ page 40).
̈ Press button è or ÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu ap-
pears in the multifunction display
(
୴ page 147).
̈ Press button j or k repeatedly
until you see the following message:
Tire Pressure Monitor
Active
Menu: R-Button
̈ Press the reset button (୴ page 145).
The following message will appear in
the multifunction display:
Restart tire
pressure monitor?
̈ Press button æ.
The following message will appear in
the multifunction display:
Tire Pressure Monitor
Restarted
After driving a few minutes the system
verifies that the current tire inflation
pressures are within the system’s
specified range. Afterwards the current
tire inflation pressures are accepted as
reference pressures and then moni-
tored.
If you wish to cancel activation:
̈ Press button ç.
Checking tire pressure electronically
with the Advanced Tire Pressure Moni-
toring System (Advanced TPMS)*,
(Canada only)
The TPMS only functions on wheels that
are equipped with the proper electronic
sensors. It monitors the tire inflation pres-
sure, as selected by the driver, in all four
tires. A warning is issued to alert you to a
decrease in pressure in one or more of the
tires.
Tire pressure inquiries are made using the
multifunction display. The present inflation
pressures are displayed only after a few
minutes’ travel time.
i
Restart the TPMS after adjusting the tire in-
flation pressure to the inflation pressure recom-
mended for the vehicle operating condition. Tire
pressure should only be adjusted on cold tires.
Observe the recommended tire inflation pres-
sure on the Tire and Loading Information placard
on the driver’s door B-pillar (
୴ page 352). Some
vehicles may have supplemental tire inflation
pressure information for driving at high speeds
(
୴ page 358) or for vehicle loads less than the
maximum loaded vehicle condition
(
୴ page 358). If such information is provided, it
can be found on the inside of the fuel filler flap.
i
This device complies with RSS-210 of Indus-
try Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.