Filter
Top Products
262
Controls in detail
Panorama roof with power tilt/sliding panel*
Raising
You can raise the tilt/sliding panel at the
rear for better ventilation of the vehicle in-
terior.
̈ Press and hold the roof panel switch in
direction of arrow 3 (
୴ page 260).
Release the roof panel switch when the
tilt/sliding panel has reached the de-
sired position.
Lowering
̈ Pull and hold the roof panel switch in
direction of arrow 4 (
୴ page 260) un-
til the tilt/sliding panel has lowered
and closed completely.
Fully opening (Express-open) the pan-
orama roof with tilt/sliding panel
̈ Pull the roof panel switch past the
resistance point in direction of
arrow 1 (
୴ page 260) and release.
The tilt/sliding panel opens complete-
ly.
Stopping the panorama roof with
tilt/sliding panel during Express-open
̈ Move the roof panel switch in any di-
rection.
The tilt/sliding panel will stop in its cur-
rent position.
Synchronizing the panorama roof with
power tilt/sliding panel
The tilt/sliding panel and its roller sun-
blinds must be synchronized
ț after the battery has been
disconnected or discharged
ț after a malfunction
ț if the tilt/sliding panel does not open
smoothly
!
Do not attempt to open or close the
tilt/sliding panel before the tilt/sliding
panel is properly synchronized. The
tilt/sliding panel could otherwise
lock-up in the open position.
If the tilt/sliding panel cannot be
closed or synchronized, see an autho-
rized Mercedes-Benz Light Truck
Center or call Roadside Assistance
(
୴ page 315).