Filter
Top Products
190
Controls in detail
Automatic transmission
̈ Press program mode selector
switch 1 repeatedly until the letter of
the desired shift program appears in
the multifunction display (
୴ page 184).
Select C for comfort driving:
ț The vehicle starts out in second
gear (both forward and reverse) for
gentler starts. This does not apply if
full throttle is applied or gear
range 1 is selected.
ț Traction and driving stability are
improved on icy roads.
ț Upshifts occur earlier even when
you give more gas. The engine then
operates at lower rpms and the
wheels are less likely to spin.
Gear selector lever one-touch
gearshifting
Even with an automatic transmission, you
can change the gears manually and limit or
extend the gear range for automatic
shifting with the gear selector lever in
position D and driving in the automatic
program mode C or S.
!
Never change the program mode when
the gear selector lever is out of
position P. This could result in a
change of driving characteristics for
which you may not be prepared.
i
The last selected program
mode (C or S) is switched on when the
engine is restarted.
!
Allow engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature
has been reached.
Shift into reverse gear R or parking
position P only when the vehicle is
stopped.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces. This may cause
serious damage to the drivetrain which
is not covered by the Mercedes-Benz
Limited Warranty.