Filter
Top Products
145
Controls in detail
Lighting
Canada only
The daytime running lamp mode is manda-
tory and therefore in a constant mode.
When the engine is running, and you shift
from a driving position to position N or P,
the low beam headlamps will switch off
with a three-minute delay.
When the engine is running, and you
ț turn the exterior lamp switch to
position C, the parking lamps
switch on additionally.
ț turn the exterior lamp switch to
position B, the manual headlamp
mode has priority over the daytime run-
ning lamp mode.
The corresponding exterior lamps
switch on (
୴ page 54).
USA only
By default, the daytime running lamp mode
is deactivated. Activate the daytime run-
ning lamp mode using the control system,
see “Setting daytime running lamp mode
(USA only)” (
୴ page 172).
When the engine is running, and you turn
the exterior lamp switch to
position C or B, the manual head-
lamp mode has priority over the daytime
running lamp mode.
The corresponding exterior lamps switch
on (
୴ page 54).
Locator lighting and night security illu-
mination
Locator lighting and night security illumi-
nation are described in the “Control sys-
tem” section, see (
୴ page 173) and
(
୴ page 174).
i
With the daytime running lamp mode
activated and the exterior lamp switch
in position M, the high beam head-
lamps cannot be switched on.
The high beam flasher is available at all
times.