Filter
Top Products
117
Controls in detail
Audio system
Seek tuning
̈ Press either the f or e button.
The radio will tune to the next receiv-
able station.
Scan tuning
̈ Press the
SC
key.
Each station with a strong signal on the
band selected will be tuned in for
8 seconds. The first scan will tune only
the stations with a high signal strength.
The second scan will tune every receiv-
able station.
By pressing either the
d, c, f or
e buttons, or the
SC
key, the scan
mode can be cancelled.
Station memory
Ten stations can be stored in the AM and
FM bands via the alpha-numeric keypad.
The “0” button corresponds to location 10.
Weatherband (WB) channels 1 to 7 can be
retrieved via the alpha-numeric keypad
and are preset at the factory.
Storing stations
̈ Hold the number button down for ap-
proximately 2 seconds.
The currently displayed frequency is
stored on the selected station button.
The storage procedure is confirmed by
a short signal tone.
Retrieving a station from memory
̈ Press the desired station button.
Direct frequency input (AM and FM
only)
̈ Select the band.
̈ Press the “ button and enter the
desired frequency using the
alpha-numeric keypad.
Frequencies outside of the frequency
ranges (frequencies specified on
page 116) will not be accepted. The
frequency input mode is cancelled if no
button is pressed within 4 seconds.