Filter
Top Products
26
10. Troubleshooting
z Even if you think the device has broken down or malfunctioned, check
once more to be sure.
z If an error occurs, read through this instruction manual thoroughly, and
check the following items in the table below. If the error or problem persists,
do not try to repair the device by yourself. Consult with the authorized
Mazda dealer where you purchased the vehicle or device.
Problem Check Item Troubleshoot
Are the batteries inserted
correctly?
Check the status of the batteries.
(Refer to p.13.)
Have the batteries run
out?
Replace the batteries with new ones.
(Refer to p.13.)
Did you press more than
one switch at the same
time? (except the warm-up
time setting operation)
Refer to the basic operation items to perform
the remote control operation correctly.
(Refer to p.14.)
Remote control
does not work
Did you try to conduct an
operation too quickly right
after another operation
was sent?
The next transmission cannot be sent while
the LCD display appears. Wait until the
display turns off before conducting an
operation.
(Refer to p.12.)
Did you make a mistake
with the "Engine start"
operation on the remote
control?
Refer to the "Engine start operation" section
on p.15.
When the function or start
switch was pressed, was
another switch pressed at
the same time or ahead of
those switches?
Do not press another switch at the same time
or ahead of those switches.
Have the engine start
conditions been satisfied?
Check the engine start conditions. (Refer to
p.14, p.16.)
Engine does
not start using
remote control
Does the Error display
appear on the LCD
monitor of the remote
control?
Refer to the "Condition Error Display" section
on p.16.
Engine stops
after starting it
with the remote
control
Are the engine stop
conditions shown in p.19
true?
The engine will stop if one of the conditions
shown in p.19 is true.