Filter
Top Products
23
9-6. Engine start operation with rear defrost start Up
z Press the function switch once.
The LCD display will appear as shown
on the right.
z Press the function switch once more
while the above LCD display is shown.
The rear defrost mark will flash.
z Press the start switch while the
above LCD display is shown until it
beeps.
After the send mark flashes, the send
operation is completed. After the send
operation is completed, the controller
will send an answer back signal.
*Press the start switch within 2 seconds after the
LCD display appears. If the start switch is not
pressed in time and the LCD display disappears,
start the procedure over again from step 1.
The LCD display will appear when the
switch is released.
ADVIC
E
The LCD display will appear when the
switch is released.
ADVIC
E
Function switch
While LCD
displays
Function
switch
Start switch
While LCD
displays