Magnadyne X11 Remote Starter User Manual


 
(Additional Wiring Required)
This feature will independently unlock the drivers door only when disarming the security
system. Pushing the button a second time within 3 seconds will unlock the other doors.
(Must be Programmed On)
If this feature is selected, the security system will automatically rearm itself within 60 seconds
after disarming with the remote transmitter. Automatic rearm will cancel if any door is opened
before the 60 second timer is up.
The override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to “ON” position (alarm will sound).
2. Within 10 seconds push and release the valet switch, the alarm will stop sounding and enter
the disarm mode. You can now start and operate the vehicle normally.
Disarming: Unlock and Disarm
(continued)
9
Two Steps Door Unlock
Automatic Rearm
Disarming without a Transmitter
The valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all
alarm functions and remote start functions are bypassed, however the remote panic feature and
remote door locks will remain operational. To use the valet mode, the system must first be
disarmed either by using your remote transmitter, or by operating the manual override sequence.
1. While in disarmed mode, turn the ignition to “Off”
position and open the drivers door.
2. Push and hold the and buttons until the
door locks cycle “Lock/Unlock”. The LED will will
flash every 5 seconds while the unit is in the valet
mode.
1. While in disarmed mode, turn the ignition to “Off” position and open the drivers door.
2. Push and hold the and buttons until the door locks cycle “Lock/Unlock”.
The LED will will be off indicating the alarm is out of the valet mode.
Remote Door
Lock
HOOD
Remote Door
Unlock
Remote Valet Mode
(System in Disarm or Valet Mode)
Enter the Valet Mode:
Exit the Valet Mode: