Filter
Top Products
Note: The transmission range may become shorter if the system is interfered by a stronger radio
frequency from sources of high voltage electric power or obstacles like tall buildings. The
transmitter uses low output powered frequency.
Turbo Timer Mode keeps the engine running after arriving at you destination for a programmable
time period of 3, 5 or 10 minutes. This allows the system’s time to conveniently cool down the
turbo charger after you have left the vehicle.
To Activate:
1. While the engine is running, set the emergency brake and place the transmission to "Park".
2. Before turning off the engine, press and release and buttons at the same time. The light
will flash to indicate the remote start has entered Turbo Timer Mode.
3. Remove the ignition key from the key cylinder. The engine will keep running.
4. Exit and secure the vehicle. The engine continues running until the preprogrammed time has
elapsed.
When the engine is running by remote start and you wish to stop the engine from running:
1. Press the button twice on the remote transmitter.
2. Move the optional remote start toggle switch to the “OFF” position (if installed).
3. Press the vehicle’s brake pedal, the engine will stop running and the parking lights turn off to
indicate the engine has stopped.
If any of the following conditions exist while the system is operating, the engine will not start or will
shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The hand brake is released (for Standard Transmission vehicles only).
4. Engine is over-RPM (Tachometer Checking Type only).
5. The preprogrammed run time (5/10/20/30 minutes) has elapsed.
6. Press the button twice on the remote transmitter under Remote Start Mode.
7. Move the optional remote start enable toggle switch to “OFF” position (if installed).
8. The vehicle refused to start running after 3 unsuccessful attempts.
17
Turn Off Remote Start
Shut Down Input for Remote Starter
Turbo Timer Mode
(Also See Installation Manual)
Interference