Filter
Top Products
16
This feature allows the vehicle to remain running after the key has been removed from the
ignition. This feature is useful for occasions when you wish to exit and lock/arm the vehicle for
short periods of time. This will keep the engine running for climate controls to stay on.
1. Before turning the engine off with the ignition key, press the button twice. The LED will flash
three times to indicate the feature is activated.
2. Turn the ignition key to the “OFF” position (the engine will stay running).
3. The engine will run until the pre-programmed run time elapsed or a shutdown input is
received.
The X11 can be programmed to start and run the engine every 3, 2 or 1 hours by time or by
temperature. The X11 can also be set to punctually start the engine at the same time the next day.
In all modes, the engine will run for the pre-set time (Default setting is 10 minutes) running time
and then shut down the same as if it were being controlled by the remote transmitter.
Important! Timer starting should be used only in open areas. Never start, or most importantly
leave a vehicle running in an enclosed area.
3, 2 or 1 Hour Timer Start without Temperature Control: (Default Setting is 3 Hours)
This feature is designed for extreme cold climate usage. The system will auto start the vehicle
every three hours to prevent the engine from freezing and creating a hard-to-start condition.
3, 2 or 1 Hour Temperature Starting Control: (Default Setting is 3 Hours)
The system can be programmed to automatically start the vehicle’s engine whenever the
temperature inside the vehicle reaches and/or drops below a preprogrammed temperature level.
The X11 system will check the interior temperature ever 3,2 or 1 hour.
Hourly Timer Start: (Runs Every 3, 2, or 1 Hours Depending on Programming)
Press the button first, within three seconds press the button. The parking lights will flash
six times and the siren/horn will sound six times. The vehicle is now in timer start mode.
Note: The hourly timer start function requires additional programming of the LCD remote
transmitter. (See Timer Setting page 20 for programming).
Daily Timer Start:
Press the button first, within three seconds press and hold the button for 3 seconds. The
parking lights will flash six times and the siren/horn will sound six times. The vehicle is now
programmed to start at the same time tomorrow (next day).
Note: The daily timer start function requires additional programming of the LCD remote
transmitter. (See Timer Setting page 20 for programming).
Exit the Timer Start:
To Cancel the timer start function, do one of the following:
1. Start the vehicle manually using the ignition key.
2. Remote start the vehicle using your remote transmitter.
Quick Stop Feature
Timer Starting Modes
Remote Start Operation
(continued)