Filter
Top Products
COLLISION WARN NOT AVAILABLE SENSOR BLOCKED SEE
MANUAL (if equipped) — Displayed when the collision warning
system radar is blocked because of poor radar visibility due to bad
weather or ice/mud/water in front of the radar. Driver can typically clean
the sensor to resolve.
PRESS BRAKE TO START (if equipped) — Displayed when the
start/stop button is pressed without the brake pedal being applied. This
is a reminder that the brake pedal must be applied when the start/stop
button is pressed in order to start the engine.
SHIFT TO PARK (if equipped) — Displayed when the start/stop
button is pressed to shut off the engine with the shift select lever in any
position other than P (Park). Refer to Fast restart feature in Push
button start system in the Driving chapter for more information.
NO KEY DETECTED (if equipped) — Displayed if the Intelligent
Access Key is not detected by the system in the following three
scenarios:
• When the start/stop button is pressed in an attempt to either start the
engine or cycle through the ignition states.
• When the engine is running and a door is opened then closed.
• When the vehicle’s speed exceeds 10 mph (16 km/h) for the first time
after starting. Refer to Push button start system in the Driving chapter
for more information.
RESTART NOW OR KEY IS NEEDED (if equipped) — Displayed
when the start/stop button is pressed to shut off the engine and a
Intelligent Access Key is not detected inside the vehicle. Refer to Push
button start system in the Driving chapter for more information.
ACCESSORY POWER ACTIVE (if equipped) — Displayed when the
vehicle is in the accessory ignition state.
STARTING SYSTEM FAULT (if equipped) — Displayed when there
is a problem with your vehicle’s starting security system; your vehicle
will not be able to start. See your authorized dealer for service.
KEY PROGRAMMED 3 KEYS TOTAL (if equipped) — Displayed
during spare key programming, when a third Intelligent Access Key is
programmed to the system.
KEY PROGRAMMED 4 KEYS TOTAL (if equipped) — Displayed
during spare key programming, when a fourth Intelligent Access Key is
programmed to the system.
Instrument Cluster
27
2010 MKT (mkt)
Owners Guide, 3rd Printing
USA (fus)